One-Point Map
Use the One-Point Map () attribute to specify the orientation of the source mesh on the destination for a Copy, Copy Face or a Copy Domain node. Using this node, the source mesh of the copy operation is transformed so that the source edge of the Edge Map node is mapped onto the destination edge with the specified orientation?, as shown in Figure 8-87.
Figure 8-87: Specifying two different selections for a One-Point Map node when copying the mesh from the smaller circle (yellow source point) to the larger circle (magenta destination point).
To add One-Point Map node, choose one of the following:
•
Right-click the Copy, Copy Face or Copy Domain node and select One-Point Map () from The Model Builder Context Menu.
•
When the Copy Face or Copy Domain node is selected in the Model Builder tree, click More Attributes () in the Mesh toolbar and select One-Point Map ().
Then enter the properties using the following sections:
Point Selection
Click the Active button to toggle between turning ON and OFF selections.
•
Activate the Point on source list and select the point that you want to define as source point in the Graphics window.
•
Activate the Point on destination list and select the point that you want to define as destination point in the Graphics window.
•
Copy
•
Copy Face
•
Copy Domain
•
Edge Map
•
Two-Point Map
•
Identical Mesh