Use the Edge Groups (
) attribute to specify the four groups of edges around a boundary (3D) or domain (2D) that are used to determine the
Mapped mesh of the boundary/domain, as seen in
Figure 8-53.
For all the settings sections, click the Active button to toggle between turning ON
and OFF
selections.
To add an Edge Groups node, choose one of the following:
Define the boundary/domain where you want to specify the edge groups. Choose Manual in the
Selection list to select the boundary/domain in the
Graphics window.
Activate the First Edge Group list and select the edges for the first edge group in the
Graphics window.
Activate the Second Edge Group list and select the edges for the second edge group in the
Graphics window.
Activate the Third Edge Group list and select the edges for the third edge group in the
Graphics window.
Activate the Fourth Edge Group list and select the edges for the fourth edge group in the
Graphics window.