Select the edges on which to specify the temperature. The Restrict to layered edges check box makes the node applicable only if a layered material is defined on the edge. If a layered material (
Material with
Layer thickness specified,
Single Layer Material,
Layered Material Link, or
Layered Material Stack) is available, its name is then displayed beside the edge index (for example,
slmat1), otherwise the edge is marked as not applicable.
Note that when the Shell type is
Nonlayered shell in the
Shells Properties section of the parent interface or node, the
Restrict to layered boundaries check box is not editable.
This section is available only when the Shell type is
Layered shell in the
Shells Properties section of the parent interface or node. You can limit the contribution to individually selected layers by clearing the
Use all layers check box. For a given
Layered Material Link or
Layered Material Stack, you get access to a list of check boxes for the selection of the individual layers.
For User defined, enter a value or expression for the
Temperature T0. Else, select an
Ambient temperature defined in an
Ambient Properties node under
Definitions.
The equation for this condition is T = T0 where
T0 is the prescribed temperature.
Physics tab with Thin Layer,
Thin Film, or
Fracture selected in the model tree:
Physics tab with Heat Transfer in Shells selected in the model tree: