Use a Create Vertices node (
) to create vertices when the geometry and mesh are empty or when the geometry is empty and the mesh includes an
Import node. Convert existing mesh vertices into vertex elements or create new vertex elements. The new vertices can be created in empty space or be created to overlap existing mesh.
Enter the properties for the Create Vertices node using the following sections:
From the Specify list, select
Mesh vertices (the default) to specify positions by clicking on mesh vertices in the Graphics window. Alternatively, choose
Coordinates to specify the positions of the vertices.
Click the Active button to toggle between turning ON and OFF the mesh vertex selection. This enables selection by clicking in the Graphics window. When the
Active button is toggled ON, the
Mesh Rendering will automatically be turned ON to facilitate the selection of vertices. It is possible enter the exact
x,
y, and (3D only)
z coordinates manually in the table, but the
Coordinates vertex specification is better suited for this purpose. Selected vertices are highlighted in the Graphics. Click a second time on the same vertex to remove it from the selection.
Valid inputs for the x,
y, and
z (3D only) fields are either arrays of the same length or scalars. If both arrays (of size bigger than one) and scalars are given, the scalars are interpreted as an array of constant value. Use the
Range button (
) if desired to create an array of coordinate values.
Use the Relative snapping tolerance field to specify a maximum distance within which the specified point will snap to the closest mesh point. A vertex element will be created at the snapped point. If there are no such mesh points within the tolerance, both a mesh point and a vertex element will be created at the specified coordinates. The value in the
Relative snapping tolerance field is relative to the size of the mesh including the added vertices. It is relative to the diameter of the bounding box and should therefore be given as a value between 0 and 1. The specified points are not allowed to be within the relative snapping tolerance of each other.