Collapse Face Regions
The Collapse face regions operation detects and removes narrow regions for a selection of faces. Narrow face regions is often the result of two edges meeting at a very sharp angle (see Figure 7-20) and may cause mesh refinements or even meshing failure. The operation detects narrow regions based on a specified width tolerance. To remove a narrow regions, the edges adjacent to it are first partitioned by creating vertices. Then, an edge with a length according to the tolerance is created between the vertices to partition the face. Lastly, the sliver face created by the partitioning is collapsed into an edge, which leaves the original face with a less narrow region.
Figure 7-20: 1. The narrow region on the selected face occurs where two of the edges meet at a very sharp angle. 2. Based on a tolerance, the narrow region is detected and vertices are created to partition the edges. 3. The original face is partitioned by adding an edge between the vertices to isolate the narrow region of the face, highlighted in blue. 4. The newly created face is collapsed into one of its longer edges, thereby removing the narrow region.
In some cases, an alternative to collapsing a narrow face region could be to remove the edges that cause the narrow region by using the Ignore Edges operation. The Remove Details operation provides a fully automated way to find and remove narrow regions within a selection of boundaries or boundaries adjacent to a selection of domains.
To use the operation, in the Geometry toolbar, from the Virtual Operations menu (), select Collapse Face Regions (). You can also select it from the Geometry node’s context menu’s Virtual Operations submenu.
Enter the properties of the operation using the following sections:
Input
Select the faces for which you want to collapse narrow face regions in the Graphics window. They then appear in the Faces list. If the geometry sequence includes user-defined selections above the Collapse Face Regions node, choose Manual to select faces, or choose one of the selection nodes from the list next to Faces.
Click the Active button to toggle between turning ON and OFF the Faces selections.
The Narrow regions tolerance controls how much of a narrow region to collapse. By default, it is set to Automatic. The default tolerance used is 0.001 times the length of the longest edge of the geometry’s bounding box. For more control, select Manual to enter a value in the Maximum width field that appears. The default value is 0.001. The tolerance is the maximum width of a face region to be considered as narrow. If you build the operation with Automatic and then switch to Manual, the Maximum width field shows the value of the parameter that was used when the operation was built. A larger Maximum width will detect wider regions than a smaller value. It will also collapse a larger portion of the face, as shown in Figure 7-21.
Figure 7-21: Collapsing a narrow face region with a smaller Maximum width value will keep a larger portion of the narrow region (upper-right image) while using a larger value for the Maximum width will remove more of the narrow region (lower-right image).