Heat Rate
This feature models a node (one-port component) of the thermal system, at which the heat rate is prescribed.
Node Connections
Set the Node name for the heat rate node.
Node Parameters
Click to select the Heat rate (the default), Convective heat rate, or Joule heating button.
Heat Rate
Enter a value or expression for P0 to prescribe it as the heat rate at the selected node of the thermal system.
Convective Heat Rate
The heat rate P is defined in function of the difference between the node temperature T and a specified external temperature, Text, by mean of a convective thermal resistance, Rconv:
Set the Area A of the surface of the convective heat flux and define the Heat transfer coefficient h used to express the convective thermal resistance as:
The default option is to enter a User defined value for the Heat transfer coefficient h.
In addition, the following options are also available to control the type of convective heat rate to model: External natural convection, Internal natural convection, External forced convection, or Internal forced convection.
For all options except User defined, select a Fluid: Air (the default), Transformer oil, Water, Moist air, or From material.
When From material is selected, choose a material available from the Materials list.
Depending of the selected option, different parameters are needed. You can refer to the Sketch section to get an illustration of the configuration.
See the Fluid feature for details about the settings related to each correlation.
Finally the external conditions should be set.
Set the Absolute pressure, pA. For User Defined, enter a value or expression. Else, select an Ambient absolute pressure defined in an Ambient Properties node under Definitions. The pressure is used to evaluate the Fluid material properties and this setting is not available for the Transformer oil and Water options.
In addition, enter an External temperature, Text. For User defined, enter a value or expression. Else, select an Ambient temperature defined in an Ambient Properties node under Definitions.
Finally, when the Fluid is Moist air, also set the External relative humidity, , and the Surface relative humidity, , used to evaluate the material properties.
Joule Heating
The heat rate P is defined as follows to model resistive heating at the node:
where Re is the electrical resistance and I is the electric current.
Set values or expressions for the Electric current, I, and the Electrical resistance, Re.
Results
Select appropriate options in the Add the following to default results in order to include the following global variables (space-independent) in the default plots:
Heat rate
Temperature
Location in User Interface
Context Menus
Ribbon
Physics Tab with Lumped Thermal System selected: