Use the Applied Force and Moment subnode to apply forces and moments on either the source or destination attachment of a joint, or directly on the joint degrees of freedom.
The Applied Force and Moment subnode can be added to the
Prismatic Joint,
Hinge Joint,
Cylindrical Joint,
Screw Joint,
Planar Joint,
Ball Joint,
Slot Joint, and
Reduced Slot Joint. The contents of the settings sections will differ between different joint types.
Select Source attachment,
Destination attachment, or
Joint to apply force and moment on the selected attachments or directly on the joint degrees of freedom.
Select Center of attachment,
Center of joint, or
User defined. For
User defined enter values or expressions for the
Location Xp.
For Source attachment or
Destination attachment, enter values or expressions for the applied force
F and applied moment
M (3D components) or
Mz. The forces or moments that you prescribe are interpreted in the selected coordinate system.
When the load is applied on Joint, the input in this section depends on the joint type. For all joints, a scalar force or moment acts directly on the single translational or rotational degree of freedom in the joint, while vector inputs have directions as given by the selected coordinate system.
Physics tab with Prismatic Joint,
Hinge Joint,
Cylindrical Joint,
Screw Joint,
Planar Joint,
Ball Joint,
Slot Joint, or
Reduced Slot Joint selected in the model tree:
Attributes>Applied Force and Moment
