COMSOL 6.2 - Plasticity

Plasticity

Use the subnode to define the properties for modeling elastoplastic materials. This material model can be used together with either a Linear Elastic Material, Nonlinear Elastic Material, or a Linear Elastic Material, Layered.

The Nonlinear Structural Materials Module is required for this feature. For details, see https://www.comsol.com/products/specifications/.

If the Composite Materials Module is available, the plasticity model can be applied to arbitrary layers in a multilayered membrane.


	See also the discussion in Layered and Nonlayered Membranes.

Shell Properties

This section is present only when the node is used under Linear Elastic Material, Layered.

Select the layer or layers for which this plasticity model is to be used.

Table 7-3: Layer Selections; Plasticity.
Selection	Use All Layers	Selection of Individual Layers
Boundary	Same as parent selection when the node is added.	When Use all layers is not selected. Only a subset of the layers selected in the parent can be selected.

If the plasticity model differs between layers, you will need to add several nodes with different layer selections. If the model is the same, and only the material data values differ, you can use a single node where is used to define the values. The data for each layer is then received from global nodes.

If there are two nodes where the same layer is selected on the same boundary, the latter will be overridden on the common selections.

•

All other settings for the node are described in the documentation for Plasticity in the Solid Mechanics interface.

•

For a general description of layer and interface selections, see The Shell Properties and Interface Selection Sections.

Location in User Interface

Context Menus

Ribbon

Physics tab with , , or node selected in the model tree: