For flexibility, the Settings window contains more properties than needed, and these properties are automatically kept consistent when you change a property. The
Specify list determines a set of independent properties that are sufficient to specify:
Enter the start and end angles for the circular arc in the Start angle and
End angle fields, respectively (unit: deg).
By default, the angles are counted clockwise. Clear the Clockwise check box to make the angles count in a counterclockwise direction.
The Short arc check box is enabled when
Principal properties is set to
Endpoints and radius. When selected, the arc will span at most 180 degrees.
Select the Resulting objects selection check box to create predefined selections (for all levels — objects, domains, boundaries, edges, and points — that are applicable) in subsequent nodes in the geometry sequence. To also make all or one of the types of resulting entities (domains, boundaries, edges, and points) that the cone consists of available as selections in all applicable selection lists (in physics and materials settings, for example), choose an option from the
Show in physics (
Show in instances if in a geometry part) list:
All levels,
Domain selection,
Boundary selection,
Edge selection, or
Point selection. The default is
Domain selection, which is suitable for use with materials and physics defined in domains. For use with a boundary condition, for example, choose
Boundary selection. These selections do not appear as separate selection nodes in the model tree. Select
Off to not make any selection available outside of the geometry sequence. From the
Color list, choose a color for highlighting the resulting objects selection. See
Selection Colors.
Select the Construction geometry check box to make the resulting objects available only in the feature’s geometry sequence. For more information, see
Construction Geometry.