COMSOL 6.2 - Periodic Condition

Periodic Condition

The node adds a periodic boundary condition. This periodicity makes the selected boundaries connected so that they are not walls, and the wall distance values are continuous across the periodic boundaries.

Boundary Selection


	The software usually automatically identifies the boundaries as either source boundaries or destination boundaries, as indicated in the selection list. This works fine for cases like opposing parallel boundaries. In other cases, right-click Periodic Condition and select Manual Destination Selection to control the destination. By default it contains the selection that COMSOL Multiphysics identifies.

Destination Selection

This section is available for specifying the destination boundaries, if needed, when the option is selected in the context menu for the node. You can only select destination boundaries from the union of all source and destination boundaries.

Orientation of Source

To display this section, click the button (

) and select in the dialog box. For information about the section, see Orientation of Source and Destination.

Orientation of Destination

This section appears if the setting for in the section is changed from the default value, , and is selected in the dialog box. For information about the section, see Orientation of Source and Destination.

Mapping Between Source and Destination

To display this section, click the button (

) and select in the dialog box. For information about the section, see Mapping Between Source and Destination.

Constraint Settings

To display this section, click the button (

) and select in the dialog box. This section contains settings for specifying the type of constraint and whether to use a pointwise or weak constraint. See Constraint Settings for more information.

•

Periodic Boundary Conditions

•

Working with Geometric Entities