The uniform color to use. Active when color is set to custom.

The description of the expression in expr. Is used in the automatic title.

Whether the title contribution should contain the description when titletype is custom.

Whether the expression should be linearized at the linearization point. Applicable only if evalmethod is harmonic.

If inheritplot is not none: Determines if arrow scale is inherited.

If inheritplot is not none: Determines if the color is inherited.

If inheritplot is not none: Determines if the deformation scale is inherited.

If inheritplot is not none: Determines if the color and data ranges are inherited.

If inheritplot is not none: Determines if the transparency settings are inherited.

If inheritplot is not none and linetype is tube or ribbon: Determines if the tube or ribbon scale is inherited.

Time corresponding to last selected solnum for transient levels.

The time to use, for transient levels. Available when data is not parent and the underlying data is transient.

If arrowlength is logarithmic: The ratio between the maximum arrow length and the arrow length below which no arrow is drawn.

The index of the solution to use, per level, or interp, but only for transient solutions. Available when data is not parent and the underlying data has multiple solutions.

Whether to specify advanced parameters when positioning method is magnitude.

The density of the streamlines. Active when posmethod is set to magnitude.

Minimum and maximum distance relative to the size of the geometry. Active when posmethod is set to magnitude.

Boundary element refinement. Active when madv is set to manual.

Approximate number of streamlines. Active when startmethod is set to number.

The element refinement to use, if resolution is set to manual. Bear in mind that this is the refinement used for the base dataset, so the number of elements in the model can increase radically if the plot uses, for example, a revolve dataset.

Controls the plot’s resolution. A finer setting results in a higher resolution by modifying the internally computed default refinement. Use custom to enter your own refinement in the refine property.

Smoothing settings. With material, smoothing is done inside domains with the same material. With internal, smoothing is done inside geometry domains. With expression, the smoothing is based on the expression in smoothexpr.

The expression to use for smoothing when smooth is set to expression.

The index of the solution to use. Available when data is not parent and the underlying data has multiple solutions.

If data is a local dataset with nontrivial data, specify solutions manually or take them from the parent plot group.

Time corresponding to last selected solnum.

The time to use, for transient problems. Available when data is not parent and the underlying data is transient.

Threshold value (0–1), if threshold is set to manual.

The title to use when titletype is manual.

Whether the title contribution should contain the type when titletype is custom.

Whether to specify advanced parameters when positioning method is uniform.

Terminating distance factor. Active when uadv is set to manual.

Fraction of streamline length to ignore. Active when uadv is set to manual.

Boundary element refinement. Active when uadv is set to manual.

The unit to use for the expression in expr. If the old unit is not valid when the expression changes, the unit property is reset to default.

Starting distance factor. Active when uadv is set to manual.

Number of planes in the x direction. Active when multiplanexmethod is set to number.

Absolute coordinates in the x direction, active when multiplanexmethod is set to coord.

Number of planes in the y direction. Active when multiplaneymethod is set to number.

Absolute coordinates in the z direction, active when multiplaneymethod is set to coord.

Number of planes in the z direction. Active when multiplanezmethod is set to number.

Absolute coordinates in the z direction, active when multiplanezmethod is set to coord.