Edge Load

Add an as a force or moment distributed along an edge.

Specify the coordinate system to use for specifying the load. From the list select from the following based on space dimension:

For 2D models (boundaries):

•

(the default)

•

(a predefined normal-tangential coordinate system)

•

Any additional user-defined coordinate system

For 3D models (edges):

•

(the default; the standard global coordinate system).

•

. This is the coordinate system defined by the beam cross-section orientation as defined in the subnode under . The local edge coordinate systems directions are available as variables for plotting using an Arrow Line plot, for example: Under in the plot settings lists of predefined expressions, select , , or .

•

Any additional user-defined coordinate system.

Force

Select a — (the default), , or . Enter values or expressions for the components.

Table 8-11:
Load Type	variable	SI unit	Geometric Entity Level	Space Dimension (Components)
Force per unit length	FL	N/m	edges boundaries	3D (x, y, z) 2D (x, y)
Force per unit volume	FV	N/m3	edges boundaries	3D (x, y, z) 2D (x, y)
Total force	Ftot	N	edges boundaries	3D (x, y, z) 2D (x, y)

•

When is selected, the given load is multiplied by the cross-section area. This option is useful for modeling body loads like gravity or centrifugal loads.

•

After selecting a , the list normally only contains . When combining the Beam interface with another physics interface, it is also possible to choose a predefined load from this list.

Moment

Enter values or expressions for the components of the moment edge load ML (3D) or Mlz (2D).

Linear Buckling

To display this section, click the button (