•
|
If Entity intersects ball is kept as the default, it includes all geometric entities that intersect the enclosing ball; that is, the selection includes all entities that are partially or completely inside the ball. If in addition the Group by continuous tangent check box is selected for a boundary or edge under the Geometric Entity Level section, all entities in each group are selected if any entity in the group intersects the ball.
|
•
|
For Entity inside ball it includes all geometric entities that are completely inside the enclosing ball. If in addition the Group by continuous tangent check box is selected for a boundary or edge under the Geometric Entity Level section, the entities in each group are selected only if all entities in the group are completely inside the ball.
|
•
|
For Some vertex inside ball it includes all geometric entities where at least some vertex is inside the enclosing ball. If in addition the Group by continuous tangent check box is selected for a boundary or edge under the Geometric Entity Level section, all entities in each group are selected if any entity in the group has at least some vertex inside the ball.
|
•
|
For All vertices inside ball it includes all geometric entities where all vertices are inside the enclosing ball. If the Group by continuous tangent check box is selected for a boundary or edge under the Geometric Entity Level section, the entities in each group are selected only if all entities in the group have all vertices inside the ball. This selection might differ slightly compared to when selecting Entity inside ball if the geometric entity is outside the ball at some points between the vertices.
|