•
|
If Entity intersects disk is kept as the default, it includes all geometric entities that intersect the enclosing disk; that is, the selection includes all entities that are partially or completely inside the disk. If in addition the Group by continuous tangent check box is selected for a boundary under the Geometric Entity Level section, all entities in each group are selected if any entity in the group intersects the disk.
|
•
|
For Entity inside disk it includes all geometric entities that are completely inside the enclosing disk. If in addition the Group by continuous tangent check box is selected for a boundary under the Geometric Entity Level section, the entities in each group are selected only if all entities in the group are completely inside the disk.
|
•
|
For Some vertex inside disk it includes all geometric entities where at least some vertex is inside the enclosing disk. If in addition the Group by continuous tangent check box is selected for a boundary under the Geometric Entity Level section, all entities in each group are selected if any entity in the group has at least some vertex inside the disk.
|
•
|
For All vertices inside disk it includes all geometric entities where all vertices are inside the enclosing disk. If the Group by continuous tangent check box is selected for a boundary under the Geometric Entity Level section, the entities in each group are selected only if all entities in the group have all vertices inside the disk. This selection might differ slightly compared to when selecting Entity inside disk if the geometric entity is outside the disk at some points between the vertices.
|