Prescribed Velocity
The Prescribed Velocity node adds a boundary or domain condition where the velocity is prescribed in one or more directions. This condition is applicable for Time Dependent and Frequency Domain studies. It is possible to prescribe a velocity in one direction, leaving the structure free in the other directions. The Prescribed Velocity node is a constraint and overrides any other constraint on the same selection.
To prescribe velocities on the top or bottom surfaces of the shell, use Prescribed Velocity, Interface.
Layer Selection
In the Prescribed Velocity node, you cannot access individual layers. Thus the selection in this section only acts as a filter for the boundary selection.The condition is applied all through the thickness of the shell..
Table 6-7: Layer Selections; Prescribed Velocity
Selection
All Layered Materials
Layered Material Definitions
Selection of Individual Layers
Boundary
Default
Selectable
Not available
Edge
Default
Selectable
Not available
•
All other settings for the Prescribed Velocity node are described in the documentation for Prescribed Velocity in the Solid Mechanics interface.
•
For a general description of layer and interface selections, see The Layer Selection Section.
•
You can prescribe velocities with a through-thickness variation by explicitly or implicitly using expressions containing the extra dimension coordinate as described in Using the Extra Dimension Coordinates.
Location in User Interface
Context Menus
 Layered Shell>Face and Domain Constraints>Prescribed Velocity
  Layered Shell>More Constraints>Prescribed Velocity (Edge)
Ribbon
Physics tab with  Layered Shell selected:
Boundaries>Face and Domain Constraints>Prescribed Velocity
Edges>More Constraints>Prescribed Velocity