|
|
1
|
In the Add Physics window, either enter a Search term or navigate the tree to locate the physics interface to be added to the Component.
|
The contents of the Add Physics window depends on the space dimension of the active model component. If there are no Component nodes in the model, the list of physics interfaces is empty.
|
2
|
Once a physics interface is clicked, review and optionally modify any dependent variable names in the Dependent variables section and, for some physics interfaces, specify the number of dependent variables.
|
3
|
When there is already a physics interface added to the Component, the existing Studies are listed under Physics interfaces in study. By default, the studies appear with a check mark (
![]() |
4
|
-
|
If Add to Component is selected, the physics interface is added to the Model Builder and becomes active in the entire model component’s geometry by default.
|
-
|
If Add to Selection is selected, the physics interface is added to the selected geometric entities in the Graphics window and a new node is added to the Model Builder. This is a method called preselection.
|