COMSOL 6.4 - Boundary Load

Use a to apply traction or pressure to boundaries.

Select a — or to specify the load in the appropriate frame.

•

Since the rotor is modeled in a rotating frame in a Solid Rotor interface, a stationary load in a frame works as a stationary load in the model. A stationary load in the frame will, however, change its direction with the angular velocity of the rotor, and therefore acts as a time-dependent load in the model.

•

In the Solid Rotor, Fixed Frame interface the above behavior of the loads in different frames is interchanged.

•

For a frequency domain analysis, a load in the frame is shifted with the rotor’s phase to give the effect of rotation in the Solid Rotor interface.

•

Similarly, a load in the frame is shifted with the rotor’s phase for a frequency domain analysis to give the effect of rotation in the Solid Rotor, Fixed Frame interface.

•

For a stationary analysis, has no influence on the analysis.

Force

Select a — , , , or .Then enter values or expressions for the load components based on the selection.

•

For and , you can define a distributed force over the selected boundary.

•

For , COMSOL Multiphysics then divides the total force by the area of the surfaces where the load is active.

•

For , a scalar input is given, and the orientation of the load is given by the normal to the boundary. The pressure is positive when directed toward the solid.


	After selecting a Load type, the Load list normally only contains User defined. When combined with another physics interface that can provide this type of load, it is also possible to choose a predefined load from this list.


Load Type	variable	SI unit
Force per reference area	fA	N/m2
Force per deformed area	fa	N/m2
Total force	Ftot	N
Pressure	p	Pa

•

You can add the Phase subnode to specify the phase of this load in a frequency domain analysis.

Location in User Interface

Context Menus

Ribbon

Physics tab with selected: