The Terminating Impedance boundary condition

specifies the terminating impedance to be ZL. Notice that the Absorbing Boundary condition is a special case of this boundary condition for the case when

The Open Circuit and Short Circuit boundary conditions are also special cases of this condition. The Terminating Impedance boundary condition is only available on exterior boundaries.

Enter the value or expression for the Impedance ZL (SI unit: Ω). The default is 50 Ω.

This section is available only if the Number of signal conductor lines is greater than one. Select an Active line from the available options to which the boundary condition is applied. The selectable items correspond to the Number of signal conductor lines and Dependent Variables settings.