Study 2
Add a study to solve the fully coupled problem. In this instance only a single diffusion coefficient will be solved for, so no parametric sweep will be required. The model will default to the parameter entered on the parameters node for the diffusion constant: 5
×
10
-11
m
2
/s.
1
In the Home toolbar, click Add Study
to open the Add Study window.
2
In the Add Study window, find the Studies subsection. In the Select Study tree, under General Studies click Stationary
.
3
In the Add study window click Add Study
.
4
In the Home toolbar, click Add Study
again to close the Add Study window.
Next, turn off the default plot groups again.
5
In the Model Builder window, click Study 2
.
6
In the Settings window for Study, locate the Study Settings section. Clear the Generate default plots checkbox.
7
In the Home toolbar, click Compute
.
to open the Add Study window.
.
.
again to close the Add Study window.
.
.