The Linear Elastic Material node adds the equations for a linear elastic truss element, and an interface for defining the elastic material properties.

By adding the following subnodes to the Linear Elastic Material node you can incorporate many other effects:

Define the linear elastic material properties. These settings are the same as described under Linear Elastic Material for the beam interface.

Select a Formulation — From study step, Total Lagrangian, or Geometrically linear to set the kinematics of the deformation and the definition of strain. When From study step is selected, the study step controls the kinematics and the strain definition.

When From study step is selected, a total Lagrangian formulation for large strains is used when the Include geometric nonlinearity checkbox is selected in the study step. If the checkbox is not selected, the formulation is geometrically linear, with a small strain formulation.

To have full control of the formulation, select either Total Lagrangian, or Geometrically linear. When Total Lagrangian is selected, the physics will force the Include geometric nonlinearity checkbox in all study steps.

Select a Strain decomposition — Automatic, Additive, or Multiplicative to decide how the inelastic deformations are treated. This option is not available when the formulation is set to Geometrically linear.

The Strain decomposition input is only visible for material models that support both additive and multiplicative decomposition of the deformation gradient.

Select the Calculate dissipated energy checkbox as needed to compute the energy dissipated by Plasticity.

Physics tab with Truss selected: