Applied Moment (Rigid Material)
Use the Applied Moment subnode to apply moments on a rigid domain. The moment that you specify is interpreted in the selected coordinate system.
Coordinate System Selection
The Coordinate system list contains all applicable coordinate systems in the model. Select a Coordinate system for specifying the directions of the moment.
In 2D, the moment is a scalar input and is not affected by the coordinate system selection.
Applied Moment
For 3D components, select the Direction of the applied moment — Space-fixed direction or Body-fixed direction.
•
For Space-fixed direction, the directions of the applied moment M are fixed with respect to the selected Coordinate system.
•
For Body-fixed direction, the directions of the applied moment M follow the rotation of the rigid domain.
Enter values or expressions for the Applied moment M.
•
For 3D components, enter the x, y, and z components of M.
•
For 2D components, enter the applied moment around the z-axis, Mz.
Linear Buckling
To display this section, click the Show More Options button () and select Advanced Physics Options in the Show More Options dialog.
If you are performing a linear buckling analysis with a combination of live and dead loads, select the Treat as dead load checkbox to indicate that the load contributions from this node are constant. The default is that a load is proportional to the load factor.
For more information about live and dead loads, see Buckling Analysis.
 
•
You can add the Phase subnode to specify the phase of this load in a frequency domain analysis.
•
You can specify this load to be a Harmonic Perturbation in a frequency domain analysis.
•
You can assign this load to a load group. See Load Cases in the Structural Mechanics Modeling chapter.
Location in User Interface
Context Menus
Solid Mechanics > Rigid Material > Applied Moment
Shell > Rigid Material > Applied Moment
Layered  Shell > Rigid Material > Applied Moment
Beam > Rigid Material > Applied Moment
Pipe Mechanics > Rigid Material > Applied Moment
Multibody Dynamics > Rigid Material > Applied Moment
Ribbon
Physics tab with Rigid Material node selected in the model tree:
Attributes > Applied Moment