Heat Transfer in Solids and Fluids (ht)
The boundaries where the heat flux condition was applied are no longer exterior boundaries, so the heat flux condition cannot be applied. Instead, a continuity condition is applied by default between the solid and the fluid domains.
Fluid 1
1
In the Model Builder windows, under Component 1 > Heat Transfer in Solids and Fluids select Fluid 1 node.
2
In the Settings window for Fluid, locate the Domain Selection section.
3
From the Selection list, choose Air.
Inflow 1
1
In the Physics toolbar click Boundaries
and choose Inflow
.
2
In the Settings window for Inflow, locate the Boundary Selection section.
3
From the Selection list, choose Inlet.
4
In the Upstream Properties section, from the
T
ustr
list, select Ambient temperature (ampr1).
Outflow 1
1
In the Physics toolbar click Boundaries
and choose Outflow
.
2
In the Settings window for Outflow, locate the Boundary Selection section.
3
From the Selection list, choose Outlet.
and choose Inflow 
.
and choose Outflow 
.