Use a Point (

) node to add points to the geometry, as shown in
Figure 7-28. This can be useful for physics properties assigned to points.

When you have added a node or finished drawing the point in the Graphics window, you can use the following section to define it or fine-tune it.
Define the position of the point by entering its coordinates in fields labeled x,
y (2D and 3D), and
z (3D);
r and
z in 2D axial symmetry;
xw and
yw in work planes. To get several points, enter a list of coordinates in each of these fields. Separate the coordinates with commas or blanks.
The coordinate system in which the point coordinates above are interpreted (for points in 3D geometries only). From the Take work plane from list, select
This sequence (the default) to use a work plane earlier in the same geometry sequence, or choose a part instance earlier in the sequence to choose a work plane from that part. From the
Work plane list, select
xy-plane (the default, for a standard global Cartesian coordinate system) or select any work plane defined above this node in the geometry sequence. If you choose a work plane, the work plane and its coordinate system appear in the
Graphics window, using an extra coordinate triad with the directions
xw,
yw, and
zw (which are then used to specify the point’s position).
Select the Resulting objects selection checkbox to create predefined selections (for all levels — objects, domains, boundaries, edges, and points — that are applicable) in subsequent nodes in the geometry sequence. To also make all or one of the types of resulting entities (points) that the point consists of available as selections in all applicable selection lists (in physics and materials settings, for example), choose an option from the
Show in physics (
Show in instances if in a geometry part;
Show in 3D in a plane geometry under a work plane in a 3D component) list:
All levels, or
Point selection. The default is
Point selection. These selections do not appear as separate selection nodes in the model tree. Select
Off to not make any selection available outside of the geometry sequence. From the
Color list, choose a color for highlighting the resulting objects selection. See
Selection Colors.
Select the Construction geometry checkbox to make the resulting objects available only in the feature’s geometry sequence. For more information, see
Construction Geometry.