Prescribed Velocity
The Prescribed Velocity node adds a boundary or domain condition where the velocity is prescribed in one or more directions. The prescribed velocity condition is applicable for Time Dependent and Frequency Domain studies. It is possible to prescribe a velocity in one direction, leaving the solid free in the other directions. The Prescribed Velocity node is a constraint and overrides any other constraint on the same selection. The Prescribed Velocity node is only available with some COMSOL products (see https://www.comsol.com/products/specifications/).
Shell Properties

Interface Selection

Coordinate System Selection
Select a coordinate system in which the given velocity components will be interpreted.
Prescribed Velocity
Select one or all of the Prescribed in x direction, Prescribed in y direction, and Prescribed in z direction check boxes (only applicable check boxes are shown based on the spatial dimension). Then enter a value or expression for vx, vy, and vz. For axisymmetric components, select one or both of the Prescribed in r direction and Prescribed in z direction check boxes. Then enter a value or expression for vr and vz. When twist is included in 2D axisymmetry, the circumferential displacement can also be prescribed.
In a stationary study, this node can either be ignored or treated as a constraint (similar to a Prescribed Displacement node with zero displacement). To control this, select an option from the Displacement in stationary study list — Free or Constrained.
You can add a Harmonic Perturbation subnode for specifying a harmonic variation of the values of the prescribed displacements in a frequency domain analysis of perturbation type.
Location in User Interface
Context Menus
Ribbon
Physics tab with Solid Mechanics selected:
Physics tab with  Layered Shell selected:
Physics tab with Membrane selected:
Physics tab with Truss selected: