Contact Pairs
Selecting Source and Destination
To decide which boundaries to assign as source and destination in a contact pair, consider the following guidelines:
-
The underlying domain has the Rigid Material material model.
-
-
-
The source boundary position is controlled by Prescribed Deformation under Moving Mesh.
If only one side of the contact pair is within a physics interface that has a Contact node, that side must be the destination side.
For efficiency, include only those boundaries that can potentially come in contact in the destination selection. All equations are formed on the destination boundary, and includes performing the contact search which can be expensive.
If it is difficult to follow the above guidelines, the same boundaries can be selected as both source and destination. Doing so results in an unbiased (or symmetric) formulation that is less sensitive to, for example, difference in stiffness or mesh density between the contacting boundaries. However, such a formulation involves evaluating equation and contact mapping at additional points and can thus be more expensive to use.
Strategies for Selecting Contact Pairs
A Contact node can reference any number of contact pairs.
A contact pair is just a definition, and does not have to be referenced by any Contact node.
Neither the source, nor the destination, in a contact pair has to be geometrically contiguous. In practice, this means that you often only need a few contact pairs in a model. The number of pairs actually needed will be determined by how many different settings that are required in the Contact Pair and Contact nodes.
If you have many contact pairs in your model, it is a good idea to manually set the Label of each pair in order to simplify the identification during subsequent selections in the Contact nodes.
Automatic Generation of Contact Pairs
Contact pairs can be automatically generated during the finalization of the geometry sequence. When Action is set to Form an assembly, you can select Create pairs, and use Contact pair as Pair type. Boundaries which are in geometrical contact with each other will then be placed in contact pairs. All contact pairs created are automatically added to the default Contact node. If you do not want to use all pairs, either delete the pairs from the model or disconnect the default Contact node in the relevant physics interface by selecting Disconnect pair. For the latter alternative, add new Contact nodes in the physics interface, and select which of available pairs to actually use for the contact analysis.
The automatic pair generation will not know which side to use as source or destination. Based on the suggestions in Selecting Source and Destination above, you may need to switch selections using the Swap Source and Destination () button in the Source Boundaries section of the contact pair settings.
Small Sliding Contact
In some situations, the relative sliding between the contacting boundaries is small. This is, for example, often the case for shrink fit simulations, when mounting a component using prestressed bolts, or for partial decohesion of two components. The sliding distance can be considered as small if it is significantly less than the length of a mesh element edge.
In such cases, it is possible to simplify the problem by selecting the Mapping Method to be Initial Configuration in the Contact Pair node. With this setting, a material point on the destination boundary will see the same material point on the source boundary throughout the entire simulation; that is, the mapping is constant. This setting will make the contact analysis run faster and convergence to be more stable.
The analysis is geometrically nonlinear also when using this option, and the contact region can still have arbitrarily large displacements and rotations.
Friction can be modeled. Even though there is no sliding in a geometrical sense, the difference in tangential displacement is computed.
You cannot mix contact pairs with the two different types of Mapping Method within the same Contact node.