•
|
When the Shell type is Layered shell in the Shells Properties section of the parent interface, the available options in the Apply to list are Top interface, Bottom interface, Exterior interfaces, and Selected interfaces. With the last option you can select the interfaces for a given layered material, by clearing the check boxes corresponding to layer interfaces where the node should not be applied in the Selection table. The top and bottom interfaces refer respectively to the upside and downside of the boundary, defined from the orientation of the normal vector. See Interface Selections for more details on the interfaces identification.
|
•
|
When the Shell type is Nonlayered shell in the Shells Properties section of the parent interface, a single layer material is defined on the boundary, and the available options in the Apply to list are Top interface, Bottom interface, and All interfaces.
|
|
See Layered Material, Layered Material Link, Layered Material Stack, Layered Material Link (Subnode), and Single Layer Materials in the COMSOL Multiphysics Reference Manual.
|
Upside and downside settings can be visualized by plotting the global normal vector (nx, ny, nz), that always points from downside to upside. Note that the normal vector (ht.nx, ht.ny, ht.nz) may be oriented differently.
|
Lumped Composite Thermal Barrier with Shells: Application Library path Heat_Transfer_Module/Tutorials,_Thin_Structure/lumped_composite_thermal_barrier_shells
|