COMSOL 6.2 - Solution

) datasets make solutions available for visualization and results analysis. Solvers automatically create datasets. By default, the name of the Solution dataset nodes include the name of the study with the solution that the dataset refers to (for example, ), but you can rename them if you want to. Right-click to select if the model contains mesh deformation. You can also right-click to add a subnode if desired or to add or subnodes under .

	Solution datasets do not contain the solution but refer to a solution stored in a solver node.

•

If there is more than one Component, select the geometry to perform visualization and results analysis for by selecting the corresponding from the list. If you want to plot solutions in a different component, right-click the dataset node and select (

). Select another component from the list in the duplicated dataset node, and then refer to that dataset in the plot groups where you want to plot the solution for that component’s geometry.

•

Select the to evaluate the coordinates in: , , , or . The default in most cases is the Material frame, and this rarely needs to be changed. This frame selection is used for all results evaluations that use the solution dataset.

•

Enter a value for the (SI unit: deg). The default is 0 degrees and evaluates complex-valued expressions by multiplying the solution in the solution dataset by a factor of exp(i*pi*phase/180) prior to expression evaluation.

•

Enter a (the default is 1; that is, no scaling) to multiply the solution by a real-valued scale factor.