COMSOL 6.2 - RemoveDetails

model.component(<ctag>).geom(<tag>).create(<ftag>,"RemoveDetails");

model.component(<ctag>).geom(<tag>).feature(<ftag>).selection("input");

model.component(<ctag>).geom(<tag>).feature(<ftag>).set(property,<value>);

model.component(<ctag>).geom(<tag>).feature(<ftag>).getType(property);

Use model.component(<ctag>).geom(<tag>).create(<ftag>,"RemoveDetails") to automatically remove small details from the geometry. You can also add extra local virtual operations using the following syntax (in this example, adding an IgnoreEdges operation):

model.component(<ctag>).geom(<tag>).feature(<ftag>).create("IgnoreEdges", "ige1");

You can then build that local virtual operation using

model.component(<ctag>).geom(<tag>).run("<ftag>/ige1");

You can also use the selection property input:

model.component(<ctag>).geom(<tag>).feature(<ftag>).selection("input");

If the RemoveDetails operation is in the automatic state, use the .problems() syntax to retrieve information on warnings (if any). The problem list is cleared if you switch to the manual state.

The following properties are available:

Table 3-145: Valid Property/Value Pairs for RemoveDetails.
Property	Values	Default	Description
automatic	on \| off	on	Mode of operation.
contangletol	double	5 degrees	Maximum allowed angular tangent deviation across a vertex or edge to be ignored.
contvertices	boolean	true	Specifies if vertices with continuous tangent are ignored.
detailsizetype	auto \| relative \| absolute	auto	Detail size type: automatic, relative, or absolute.
input	Selection		Entities for which to remove small details.
maxrelsize	double	0.001	Maximum relative detail size, relative to size of geometry.
maxabssize	double		Maximum absolute detail size.
selection	geometry \| entities	geometry	Remove small details from the entire geometry or from geometric entities specified using the input.
shortedges	boolean	true	Specifies if short edges are removed.
sliverfaces	boolean	true	Specifies if sliver faces are removed.
smallfaces	boolean	true	Specifies if small faces are removed.
thindomains	boolean	true	Specifies if thin domains (that is, domains with a thickness less than the specified detail size) are removed.