The Porous Medium node adds the equations for modeling flow through porous domains. By default these are Equation 7-1 and Equation 7-2 (excluding any mass sources).

For a steady-state problem the first term in Equation 7-1 disappears. When Mass Source is active Equation 7-2 is of the following form:

The Porous Medium feature has two default subfeatures — the Fluid subfeature where the fluid density ρ (SI unit: kg/m3) and dynamic viscosity μ (SI unit: Pa·s) are defined and the Porous Matrix subfeature where the permeability κ (SI unit: m2) and porosity εp (dimensionless) are specified.

Select a coordinate system from the Coordinate system list for the interpretation of directions in anisotropic material properties. The default is the Global coordinate system, and the list contains any additional orthonormal coordinate system (except boundary coordinate systems) added under the Definitions node.

The subnodes inherit these coordinate system settings. In particular, the Permeability or Hydraulic conductivity (in the Porous Matrix subnode) should be set according to the coordinate system selected in this section.