Viscoelasticity
Use the Viscoelasticity subnode to add viscous stress contributions to a Layered Linear Elastic Material or to a Layered Hyperelastic Material.
If the Composite Materials Module analysis is available, the viscoelastic model can be applied to arbitrary layers in a multilayered shell.
See also Layered and Nonlayered Shells.
Shell Properties
Select the layer or layers for which this viscoelastic model is to be used.
Table 5-4: Layer Selections; Viscoelasticity
Selection
Use All Layers
Selection of Individual Layers
Boundary
Same as parent selection when the node is added.
When Use all layers is not selected.
Only a subset of the layers selected in the parent can be selected.
If the viscoelastic model differs between layers, you will need to add several Viscoelasticity nodes with different layer selections.
If the same layer is selected in two Viscoelasticity nodes being active on the boundary, then there will be two viscoelastic contributions.
•
All other settings for the Viscoelasticity node are described in the documentation for Viscoelasticity in the Solid Mechanics interface.
•
For a general description of layer and interface selections, see The Shell Properties and Interface Selection Sections.
Location in User Interface
Context Menus
Shell>Layered Linear Elastic Material>Viscoelasticity
Shell>Layered Hyperelastic Material>Viscoelasticity
Ribbon
Physics tab with Layered Linear Elastic Material or Layered Hyperelastic Material node selected in the model tree:
Attributes>Viscoelasticity