Thickness
Use this node with 2D components to model domains with another thickness than the overall thickness that is specified in the Heat Transfer interface Physical Model section. In 2D geometries, the temperature is assumed to be constant in the out-of-plane direction (z direction with default spatial coordinate names). The heat equation is modified to take that into account. See Equation 4-172 and Equation 4-173.
Thickness
Specify a value for the Thickness dzof the domain in the out-of-plane direction. This value replaces the overall thickness in the domains that are selected in the Domain Selection section, and is used to multiply some terms into the heat equation.
The Thickness feature is disabled when at least one of the multiphysics couplings (Heat Transfer with Surface-to-Surface Radiation, Heat Transfer with Radiation in Participating Media, Heat Transfer with Radiative Beam in Absorbing Media) is active while solving on the same domain. This is noticed through a warning node displayed under Compile Equations. The radiation interfaces assume an infinite medium in the out-of-plane direction, they are thus not compatible with these features.
Out-of-Plane Heat Transfer
Location in User Interface
Context Menus
Heat Transfer in Solids and Fluids>Thickness
Heat Transfer in Solids>Thickness
Heat Transfer in Fluids>Thickness
Heat Transfer in Porous Media>Thickness
Heat Transfer in Building Materials>Thickness
Bioheat Transfer>Thickness
Ribbon
Physics tab with interface as Heat Transfer in Solids and Fluids, Heat Transfer in Solids, Heat Transfer in Fluids, Heat Transfer in Porous Media, Heat Transfer in Building Materials, or Bioheat Transfer selected:
Domains>interface>Thickness