Periodic Condition
Use this node to add periodic temperature conditions to boundary pairs.
Boundary Selection
Destination Selection
This section is available for specifying the destination boundaries, if needed, when the Manual Destination Selection option is selected in the context menu for the Periodic Condition node. You can only select destination boundaries from the union of all source and destination boundaries.
Constraint Settings
To display this section, click the Show More Options button () and select Advanced Physics Options in the Show More Options dialog box. This section contains settings for specifying the type of constraint and whether to use a pointwise or weak constraint. See Constraint Settings for more information.
Periodic Condition
Enter a Temperature offset ΔT to the temperature periodicity. The default value is 0 K, so that the source and destination temperatures are equal.
Orientation of Source
To display this section, click the Show More Options button () and select Advanced Physics Options in the Show More Options dialog box. For information about the Orientation of Source section, see Orientation of Source and Destination.
Mapping Between Source and Destination
For information about the Mapping Between Source and Destination section, see Mapping Between Source and Destination.
Location in User Interface
Context menus
Ribbon
Physics Tab with interface as Heat Transfer in Solids, Heat Transfer in Fluids, or Heat Transfer in Solids and Fluids selected: