Wall
The Wall node adds a selection of boundary conditions that describe the existence of a solid wall. The Wall node by default specifies no gas flux for the gas phase.
Liquid Boundary Condition
Select a Liquid boundary conditionNo slip (the default) or Slip.
No Slip
No slip is the default boundary condition for the liquid. A no slip wall is a wall where the liquid velocity relative to the wall velocity is zero. For stationary walls, it sets the liquid velocity to zero at the wall:
For turbulent bubbly flows, the no slip condition may either be prescribed exactly or modeled using automatic wall treatment or wall functions depending on the Wall Treatment setting in the Turbulence section of the interface settings.
When Wall functions are selected, the Apply wall roughness option becomes available. Click to select the Apply wall roughness check box to apply the roughness correction. When the check box is selected, the default Roughness model is Sand roughness, which is derived from the experiments by Nikuradse. Select Generic roughness to specify more general roughness types.
For Sand roughness enter an Equivalent sand roughness height kseq (SI unit: m). The default is 3.2 micrometers.
For Generic roughness enter a Roughness height ks (SI unit: m). The default is 3.2 micrometers. Then enter a Roughness parameters Cs (dimensionless). The default is 0.26.
Slip
Sets the velocity component normal to the wall to zero:
Gas Boundary Condition
From the list, select a Gas boundary condition for the gas phase on the wall — No gas flux (the default), Gas concentration, Gas outlet, Gas flux, or Symmetry.
Gas Concentration
For Gas concentration enter the Effective gas density (SI unit: kg/m3). The default is 0 kg/m3.If Solve for interfacial area is selected, also select either the Bubble number density (the default) or the Bubble diameter and gas density button.
For Bubble number density enter the Bubble number density n0 (SI unit: 1/m3). The default is 1000 1/m3.
For Bubble diameter and gas density enter the Bubble diameter db (SI unit: m) (the default is 1 mm) and Density, gas phase ρg (SI unit: kg/m3) (the default is 1 kg/m3).
Gas Flux
For Gas flux enter the Gas mass flux (SI unit: kg/(m2·s)) (the default is 0 kg/(m2·s)) and if the Solve for interfacial area check box is selected on the physics interface, the Number density flux Nn (SI unit: 1/(m2·s)). The default is 0 (1/(m2·s)).
Wall Movement
This section contains controls to describe the wall movement relative to the spatial frame.
The Translational velocity setting controls the translational velocity, utr. The list is per default set to Automatic from frame. When Automatic from frame is selected, the physics automatically detects if the spatial frame moves. If there is no movement, utr is set to 0. If the frame moves, utr becomes equal to the frame movement. utr is accounted for in the actual boundary condition prescribed in the Liquid boundary condition section.
When Manual is selected from Translational velocity selection list, the Velocity of moving wall, utr can be prescribed manually. Specifying the translational velocity manually does not automatically cause the associated wall to move. An additional Moving Mesh interface needs to be added to physically track the wall movement in the spatial reference frame.
The Sliding wall option is appropriate if the surface is sliding in its tangential direction. A velocity is prescribed at the wall and the boundary itself does not have to actually move relative to the reference frame.
Constraint settings
This section is displayed by clicking the Show More Options button () and selecting Advanced Physics Options.
Wall in the Single-Phase Flow interfaces