|
•
|
When Small plastic strains is selected in the Plasticity Model list, specify the values for the components of the Plastic strain tensor. From the Plastic strain tensor list, select Do not set or User defined. The default User defined values are zero for all components of the Plastic strain tensor.
|
|
•
|
When Large plastic strains is selected in the Plasticity Model list, specify the values for the components of the Plastic deformation gradient inverse. From the Plastic deformation gradient inverse list, select Do not set or User defined. The default User defined value is the identity tensor.
|
|
•
|
If Armstrong-Frederick or Chaboche is selected from the Kinematic Hardening Model list, specify the values for the components of the Back strain tensor. From the Back strain tensor list, select Do not set or User defined. The default User defined values are zero for all components of the Back strain tensor.
|
|
•
|
When Small plastic strains is selected in the Plasticity Model list, specify the values for the components of the Plastic strain tensor. From the Plastic strain tensor list, select Do not set or User defined. The default User defined values are zero for all components of the Plastic strain tensor.
|
|
•
|
When Large plastic strains is selected in the Plasticity Model list, specify the values for the components of the Plastic deformation gradient inverse. From the Plastic deformation gradient inverse list, select Do not set or User defined. The default User defined value is the identity tensor.
|
|
•
|
From the Equivalent plastic strain in the matrix material list, select Do not set or User defined. The default User defined value is zero.
|
|
•
|
From the Porosity rate list, select Do not set or User defined. The default User defined value is zero.
|
|
•
|
From the Plastic strain tensor list, select Do not set or User defined. The default User defined values are zero for all components of the Plastic strain tensor.
|
|
•
|
From the Plastic strain tensor list, select Do not set or User defined. The default User defined values are zero for all components of the Plastic strain tensor.
|
|
•
|
From the Consolidation pressure rate list, select Do not set or User defined. The default User defined value is zero.
|
|
•
|
When Extended Barcelona Basic is selected from the Material model list, specify the value for the Suction rate. From the Suction rate list, select Do not set or User defined. The default User defined value is zero.
|
|
•
|
When Hardening Soil is selected from the Material model list, specify the value for the Plastic shear strain. From the Plastic shear strain list, select Do not set or User defined. The default User defined value is zero.
|