The software provides automatic detection of details and regions that might cause problems. Depending on the severity of the problem, the meshing operations display the information in Information Nodes, Warning Nodes, or Error Nodes.

Information nodes () appear when a mesh can be built but the meshing algorithms determine that there is something that might deserve your attention. This can be very small geometry details (small faces, short edges etc.) or that mesh elements of low quality appeared. Check the information message and any selection of entities to determine if something needs to be modified and how. Low quality elements can lead to difficulties for the solver to converge or make the solution sensitive to small changes in the mesh.

For elements of low quality, it is useful to plot elements as described in Displaying Mesh Element Quality and the Mesh Element Size. Use the information about the minimum element quality in the Information node to set an appropriate value for the Element Filter expression.

Information, Warning and Error nodes can contains details with coordinates for the location of the problem, indicated by red points in the Graphics window. Select a location from the list and click the Center at Coordinates button to automatically center the camera and zoom in on the problematic area. For 3D meshes, click the Clip Around Coordinates button to add a Clip Sphere around the coordinates. This makes it easier to investigate the problematic area, especially if it is located inside a complex geometry. Click the Remove Clipping button in the Settings window to remove the Clip Sphere.

Warning nodes () appear when a mesh can be built but might need some extra tuning to be suitable for simulations. Check the warning message and any selection of entities. There is often more than one level of warnings providing details of the cause, so check all subnodes if any. It is possible to continue the simulation with warning nodes in the meshing sequence and you may still get a valid result. However, if you get problems in the simulation or obtain unexpected results, the warnings might indicate the cause.

If a problem occurs when you build a meshing sequence, it continues if possible; otherwise, the build stops. Continuing means that geometric entities where the operation failed are skipped and the problems are reported as Error nodes () under the operation node. The build process continues with remaining nodes in the meshing sequence.

If the mesh generation cannot continue, all building stops. The operation gets Warning status if some entities could be meshed, indicated by an orange triangle in the lower-right corner of the operation’s icon (see Dynamic Nodes in the Model Builder). If nothing could be built, the operation gets Error status, which the program indicates by adding a red cross in the lower-right corner of the operation’s icon. If the operation is part of a sequence build, the build stops and the preceding node becomes the current node.

When the building of the meshing sequence is completed, an error window appears to show the first error reported. If there are several errors, you have to manually inspect the sequence for Information, Warning, and Error nodes.