Applied Force (Rigid Connector)
Use the Applied Force to apply a force to the rigid connector. The force can act at an arbitrary position in space, and if it is not located at the center of rotation, there is also a moment contribution. The force that you specify is interpreted in the selected coordinate system.
Coordinate System Selection
The Coordinate system list contains any applicable coordinate systems that the model contains. Select a Coordinate system for specifying the directions of the force.
Location
Select an option from the list: Center of rotation or User defined. This is the location where the force is applied.
For Center of rotation, the location of the load is taken as the center of rotation as defined in the parent Rigid Connector node.
For User defined, enter the Location (global coordinates), Xp, in the table.
Select the Offset check box to add an optional offset vector to the definition of the location. Enter values for the offset vector Xoffset.
The location used is the sum of the vector obtained from any of the input methods and the offset vector.
Applied Force
Select the Direction of the applied force — Space-fixed direction or Body-fixed direction.
For Space-fixed direction, the directions of the applied force F are fixed with respect to the selected Coordinate system.
For Body-fixed direction, the directions of the applied force F follow the rotation of the rigid domain.
Enter values or expressions for the components of the Applied force F. The direction coordinate names can vary depending on the selected coordinate system.
You can add the Phase subnode to specify the phase of this load in a frequency domain analysis.
Location in User Interface
Context Menus
Ribbon
Physics tab with Rigid Connector node selected in the model tree: