Edge Load
Add an Edge Load to 3D components to apply a force distributed along an edge.
Shell Properties

Force
Select a Load typeForce per unit length or Total force. Then enter values or expressions for the components in the matrix based on the selection:
The total force Ftot. COMSOL Multiphysics then divides the total force by the volume where the load is active.
After selecting a Load type, the Load list normally only contains User defined. When combining with another physics interface that can provide this type of load, it is also possible to choose a predefined load from this list.
You can add the Phase subnode to specify the phase of this load in a frequency domain analysis.
Location in User Interface
Context Menus
Ribbon
Physics tab with Solid Mechanics or Multibody Dynamics selected:
Physics tab with Layered Shell selected: