Rotating Frame
Centrifugal, Coriolis, and Euler forces are “fictitious” volume forces that need to be introduced in a rotating frame of reference, since it is not an inertial system. Use a Rotating Frame node to add the effect of these forces. The forces are generated by all selected features in the physics interface having a density, mass, or mass distribution. You select boundaries, and all edges and points which belong to the selection are automatically included.
Shell Properties
As the a frame rotation always acts on the entire structure, it is not possible to select individual layers. The selection in this section only acts as a filter for the boundary selection.
Table 6-43: Layer Selections; Rotating Frame
Selection
Use All Layers
Selection of Individual Layers
Boundary
Same as interface selection when the node is added.
No
•
All other settings for the Rotating Frame node are described in the documentation for Rotating Frame in the Solid Mechanics interface.
•
For a general description of layer and interface selections, see The Shell Properties and Interface Selection Sections.
•
You can assign this load to a load group. See Load Cases in the Structural Mechanics Modeling chapter.
Location in User Interface
Context Menus
Layered Shell>Face and Volume Loads>Rotating Frame
Ribbon
Physics tab with Layered Shell selected:
Boundaries>Face and Volume Loads>Rotating Frame