Rigid Motion Suppression

The node adds a minimum number of constraints required to suppress any rigid body modes. The constraints are selected so that there will be no reaction forces if the external loads are self-equilibrating. If you need to constrain several objects which are not physically connected, you must add as many nodes as there are disconnected objects.

Shell Properties

As the constraints are added automatically to the geometrical selection, it is not possible to select individual layers. The selection in this section only acts as a filter for the boundary selection.

Table 6-39: Layer Selections; Rigid Motion Suppression
Selection	Use All Layers	Selection of Individual Layers
Boundary	Same as interface selection when the node is added.	No


	All other settings for the Rigid Motion Suppression node are described in the documentation for Rigid Motion Suppression in the Solid Mechanics interface.

Location in User Interface

Context Menus

Ribbon

Physics tab with selected: