Prescribed Displacement

The node adds a condition where the displacements are prescribed in one or more directions to the selected geometric entity (boundary, edge, or point).

If a displacement is prescribed in one direction, this leaves the material free to deform in the other directions.

To prescribe displacements on interfaces between the material layers, use Prescribed Displacement, Interface.

Shell Properties

Select the layer or layers on which this constraint is to be used.

Table 6-25: Layer Selections; Prescribed Displacement
Selection	Use All Layers	Selection of Individual Layers
Boundary, Edge, Point	Same as interface selection when the node is added.	When Use all layers is not selected. Only a subset of the layers selected in the physics interface can be selected.

If the same layer is selected in two nodes being active on the same boundary, the second definition will override the previous.

•

All other settings for the node are described in the documentation for Prescribed Displacement in the Solid Mechanics interface.

•

For a general description of layer and interface selections, see The Shell Properties and Interface Selection Sections.

•

You can prescribe displacements with a through-thickness variation by explicitly or implicitly using expressions containing the extra dimension coordinate as described in Using the Extra Dimension Coordinates.

Location in User Interface

Context Menus

Ribbon

Physics tab with selected: