Periodic Condition (Heat Transfer interface)
Use this node to add periodic temperature conditions to boundary pairs. The Destination Selection subnode is available from the context menu (right-click the parent node) or from the Physics toolbar, Attributes menu.
For information about the Orientation of Source section, see Orientation of Source and Destination in the COMSOL Multiphysics Reference Manual.
Periodic Condition
Enter a Temperature offset ΔT to the temperature periodicity. The default value is 0 K, so that the source and destination temperatures are equal.
Convection Cooling of Circuit Boards—3D Forced Convection: Application Library path Heat_Transfer_Module/Power_Electronics_and_Electronic_Cooling/circuit_board_forced_3d
Location in User Interface
Context menus
Heat Transfer>Periodic Condition
Heat Transfer in Solids>Periodic Condition
Heat Transfer in Fluids>Periodic Condition
Heat Transfer in Porous Media>Periodic Condition
Bioheat Transfer>Periodic Condition
Ribbon
Physics Tab with interface as Heat Transfer, Heat Transfer in Solids, Heat Transfer in Fluids, Heat Transfer in Porous Media, Heat Transfer in Building Materials or Bioheat Transfer selected:
Boundaries>interface>Periodic Condition