Physics Exclusive and Contributing Node Types
The nodes for the physics interfaces and features are in a sequence, which acts like a macro that the software runs in a top-down order. Depending on the selection for each node, a node can totally or partially override, or shadow, a node earlier in the sequence. How the software treats these nodes depends on the relationship. There are two different types of nodes: exclusive and contributing (see Figure 3-8)..
The exclusive and contributing nodes maintain the described behavior only in relation to similar types of nodes within the same physics interface (for example, you can have a temperature constraint and a pressure constraint for the same boundary in the same model component).
What the node looks like in the Model Builder is based on the space dimension. See Physics Feature Nodes by Space Dimension.
Exclusive Nodes
The use of an exclusive node means that only one can be active for a given selection. That is, if you add another exclusive node (for example, an identical node) with the same selection, the first exclusive node is overridden and thus has no effect.
Typical exclusive nodes include model equations, initial values, and boundary conditions that are constraints, such as prescribed values for displacements, temperatures, pressures, and so on, including special variants of these such as ground conditions in electromagnetics and fixed constraints in structural mechanics. Also some boundary conditions that are not constraints but have a definitive meaning are exclusive nodes — for example, electric insulation, thermal insulation, and no-flow conditions. Depending on the selections for each node, an exclusive node can override another node partially. Nodes are exclusive only within their specific physics interface. When a node is selected in the Model Builder tree, nodes that are overridden by the selected node have a red arrow in the lower-left corner of the icon (), and nodes that override the selected node display a red arrow in the upper-left corner of the icon ().
Contributing Nodes
A contributing node means you can have more than one of these nodes with the same selection and that the software adds these together when evaluating the model. Typical contributing nodes are loads, fluxes, and source terms, where you can have more than one of each type that is active on the same domain or boundary, for example. The total effect is then a sum of each contributing node. When a node is selected in the Model Builder tree, the tree shows other nodes, which the current node contributes with, indicated using a yellow dot to the left of the icon (for example, in this boundary level icon ). See also Figure  for an example.
Listing Overrides and Contributions
If your preferences include showing the Override and Contribution section in the Settings windows for physics nodes, you can find the following information about how exclusive and contributing nodes interact in the model. Click the Show button () and select Override and Contribution from the Model Builder to display the information as in Figure 3-8 and described below.
•
The Overridden by list contains the names of the nodes that the selected node is overridden by. The selected node is then overridden by these nodes at least partially, and the Selection list contains (overridden) for the geometric entities (boundaries, for example) where it is overridden. The nodes that the selected node is overridden by are indicated using a red arrow in the lower-left corner of the icon such as in this boundary level icon .
•
The Overrides list contains the names of the nodes that the selected node overrides (where the current node is active). The nodes that the selected node overrides are indicated using a red arrow in the upper-left corner of the icon such as in this boundary level icon .
•
The Contributes with list contains the names of the nodes that the selected node contributes with for at least some shared selection. The nodes that the selected node contributes with are indicated using a yellow dot to the left of the icon such as in this boundary level icon .
If a physics node is disabled locally in a study step using the Physics and Variables Selection section in the study step’s Settings window, the indications of overrides and contributions in the Model Builder are unchanged (but disabled physics nodes get an asterisk to indicate that their state has been changed in at least one study step). The local variables and physics tree in the study step’s Settings window, on the other hand, display the overrides and contributions taking the disabled nodes into account.
Figure 3-8: The Override and Contribution section lists other physics nodes that the selected node is overridden by, overrides, or contributes with.
•
Physics Node Status
•
Physics and Variables Selection
•
Physics Interface Default Nodes