IgnoreVertices
Ignore vertices by removing the selected vertices that are isolated or that are adjacent to precisely two edges.
Syntax
model.component(<ctag>).geom(<tag>).create(<ftag>,"IgnoreVertices");
model.component(<ctag>).geom(<tag>).feature(<ftag>).selection(property);
model.component(<ctag>).geom(<tag>).feature(<ftag>).set(property,<value>);
model.component(<ctag>).geom(<tag>).feature(<ftag>).getType(property);
Description
Use model.component(<ctag>).geom(<tag>).create(<ftag>,"IgnoreVertices") to ignore vertices.
Use model.component(<ctag>).geom(<tag>).feature(<ftag>).selection("input") to select the vertices to ignore. The default selection is empty.
The feature removes the selected vertices that are isolated or that are adjacent to precisely two edges. If a vertex is adjacent to two edges, the operation forms a composite edge. The output object is a virtual geometry.
The following properties are available:
Table 3-63: Valid Properties
on | off
Use keepformesh to keep the ignored vertices while meshing, to help you in constructing the mesh.
Example
Create an ellipse and ignore vertices 1 and 3, which gives you two remaining edges in the final geometry.
Code for Use with Java
Model model = ModelUtil.create("Model");
model.component().create("comp1");
GeomSequence g = model.component("comp1").geom().create("geom1", 2);
model.mesh().create("mesh1", "geom1");
g.create("e1", "Ellipse");
g.run("fin");
g.create("igv1", "IgnoreVertices");
g.feature("igv1").selection("input").set("fin", 1, 3);
g.run();
Code for Use with MATLAB
model = ModelUtil.create('Model');
model.component.create('comp1');
g = model.component('comp1').geom.create('geom1', 2);
model.mesh.create('mesh1', 'geom1');
g.create('e1', 'Ellipse');
g.run('fin');
g.create('igv1', 'IgnoreVertices');
g.feature('igv1').selection('input').set('fin', 1, 3);
g.run;
See Also
CompositeEdges, IgnoreEdges, IgnoreFaces, MeshControlVertices