Thermal Expansion (for constraints)
Add the Thermal Expansion subnode to a constraint (Fixed Constraint or Prescribed Displacement) to prescribe a deformation of the constrained boundary caused by changes in temperature of the surroundings. This makes it possible to reduce the stresses caused by such boundary conditions.
The thermal strain depends on the coefficient of thermal expansion α, the temperature T, and the strain-free reference temperature Tref as
The Thermal Expansion subnode is only available with some COMSOL products (see http://www.comsol.com/products/specifications/).
Thermal Expansion Properties
Specify the thermal properties that define the thermal strain. This is a description of the thermal expansion of surroundings idealized by the constraints.
Select Inherit from domain to take the thermal expansion data from the domain being constrained. This should only be used when:
•
The temperature and the thermal expansion coefficient do not have a spatial variation.
•
The virtual surrounding material has the same thermal expansion as the domain itself.
When Inherit from domain is not selected, enter:
•
A value or expression for Temperature T, specifying the temperature distribution of the surrounding material. Any temperature variation must be an explicit function of the material frame coordinates. It is not possible to use a computed temperature distribution.
•
The Coefficient of thermal expansion α. As a default, values From material are used. This requires that a material has been assigned to the boundaries, edges, or points where the constraint is active.
For User defined select Isotropic, Diagonal or Symmetric to enter one or more components for a general coefficient of thermal expansion tensor α. When a non-isotropic coefficient of thermal expansion is used, the axis orientations are given by the coordinate system selected in the Coordinate System Selection section.
•
A value or expression for the Strain reference temperature Tref that is the temperature at which there are no thermal displacements at the constraints.
Enter the coordinates of the Reference point, the point where the displacement is zero. The choice of reference point only affects the rigid body motion. If there are several different constraints with a Thermal Expansion subnode, the same reference point should usually be selected in all of them.
•
Constraints and Thermal Expansion in the Structural Mechanics Modeling chapter.
•
Thermal Expansion of Constraints in the Structural Mechanics Theory chapter.
Location in User Interface
Context Menus
Solid Mechanics>Fixed Constraint>Thermal Expansion
Solid Mechanics>Prescribed Displacement>Thermal Expansion
Membrane>Fixed Constraint>Thermal Expansion
Membrane>Prescribed Displacement>Thermal Expansion
Multibody Dynamics>Fixed Constraint>Thermal Expansion
Multibody Dynamics>Prescribed Displacement>Thermal Expansion
Ribbon
Physics tab with Fixed Constraint or Prescribed Displacement node selected in the model tree:
Attributes>Thermal Expansion