Use this subnode to specify the temperature on a set of lines (geometrical edges in 3D or geometrical points in 2D and 2D axisymmetric) that represent the boundaries of a thin domain (layer, film, fracture, or shell). Only edges (3D) or points (2D and 2D axisymmetric) adjacent to the boundaries can be selected in the parent node.
For User defined, enter a value or expression for the
Temperature T0. Else, select an
Ambient temperature defined in the
Ambient Settings section of a Heat Transfer or Heat Transfer in Shells interface.
The equation for this condition is T = T0 where
T0 is the prescribed temperature.
Physics Tab with Thin Layer, Thin Film, or Fracture selected in the model tree:
Attributes>Temperature
Physics Tab with Heat Transfer in Thin Shells selected in the model tree:
Support>Heat Transfer in Thin Shells>Temperature
Pairs>Temperature
with
Support as
Egdes in 3D and
Points in 2D.
) and select Advanced Physics Options.
